I wish to share with you the approach of making a one-size wire snake ring. The snake seems fairly uncommon, it appears fascinating and anybody could make it with personal arms from a wire.
So, you want:
Be taught: Methods to make a snake ring out of wire
- copper wire, diameter 1,3 / 0,8 / 0,3 mm
- a bead — stone or some other
- 4 copper beads, diameter 2 and three mm
- round-nose pliers
- fuel burner
- floor for soldering
- engraver (or needle file)
- sprucing paste
Step 1. Making a base
Take a minimize of the thickest wire. On this case, I used diameter 1.3, however you may take it within the vary of 1-1.5 mm.
Go away a few centimeters free from the sting, make a minimize of about 2/3 of the thickness with the graver or needle file. Thus, you’d simply bend the wire at an accute angle and solder the tip.
Utilizing pliers, bend the perimeters and solder like within the image under. I used tender copper-phosphorus solders (bought in a syringe), you may take it within the type of a wire.
After al is soldered, sharpen the tip with the graver or a needle file, correctly sand it.
Then take a cylindrical object and wrap the wire forming the ring.
Utilizing pliers, bend the ends like waves.
Once more take the needle file and sharpen the tip.
Rigorously sand the tip and wrap all in a spiral with pliers.
Take a small hammer and hit the tip. Sand nicely once more to take away all unevenness left by the hammer.
Step 2. Make a muzzle
Choose a stone bead to insert it into the top. Generally, it’s important to discover a stone becoming the loop, it takes time. Wire it to the bottom.
After the stone is fastened, add two copper beads (eyes) with the diameter of 0.3 mm.
Then take a small wire minimize and make a clean like within the photograph under. It covers the bead and eyes.
Once more, repeat the steps with soldering and sanding.
Tape the clean to the top.
After fixing, bend backwords barely as footage under.
Take small copper beads, add them by one on the edges and embellish wiht winding wire 2×2 between the bottom of the top and the higher element.
The top is completed.
Step 3. Wrapping the bottom
Now take our second piece of wire, 0,8 mm diameter. Sharpen the sting, sand and twist it right into a spiral.
Go the ball beneath the tip of the higher factor on the top and wind it to the bottom.
Now my favorite half follows 🙂 Take an extended piece of skinny wire (0.3 mm) and start to twist the 2 wires along with the two×3 winding.
Transfer on across the total size of the snake.
If you attain the tip of the tail, minimize off the surplus and sharpen the tip, place it inside the massive spiral.
ggstore.internet the merchandise within the citric acid answer to take away soot, oxides after soldering and so forth.
Clear the product totally with dishwashing detergent, then patinate. Now I exploit sulphur liver. And I additionally came upon that the result’s significantly better when the product is rubbed correctly with a tough denim fabric 🙂
Patinate, polish and benefit from the closing consequence 🙂
Thanks on your consideration! 🙂